Manually connecting LWAPP access-points to controller

 

When our LWAPP access-points have to work in H-REAP mode or  even on loca mode but on  different subnet than controller and we cannot set dns record or dhcp option we still can force him to connect to WLC but we have to do this manually.

Configuration is easy, one line.

1.Connect to Access-point via console cable

2.Go to enable mode(password is cisco or Cisco by default - change it later on controller)

3.Configure AP with ip of controller

#lwapp ap controller ip address 10.14.224.200

 

 

 

 

 dzbanek 2013-07-09

This site uses cookies. Some of the cookies we use are essential for parts of the site to operate and have already been set. You may delete and block all cookies from this site, but parts of the site will not work.