Cisco WLC - firmware upgrade

 

Assumptions

 

  • This manual covers firmware upgrade on 4400 series WLC however on different controllers procedure is the same.
  • Until we start the upgrade process we have to check if we can upgrade directly to new version of we have to first upgrade to transitive version.
  • We will use FTP server for copying files.It is better solution than tftp especially if contoller is upgraded remotely.
  • In this case we will upgrade firmware to version 7.0.235.
 
  • 1.Copy firmware image into our controller via FTP.

 

wlc-fw_upgrade1.png

  • 2.Restart controller to activate new firmware.

wlc-fw_upgrade2.png

GUI allows us to save changes before reloading..


  • 3.Wait few minutes to download new firmware by access-points.


wlc-fw_upgrade3.png

If your access-points are working in "H-REAP" mode during downloading process they are shown as a "Local".


wlc-fw_upgrade4.png


  • 4.Copy "emergency image".


wlc-fw_upgrade5.png

Emergency image is not mandatory but is very helpfull in case of problems.



wlc-fw_upgrade6.png


Restart controller.

  • 5.Check running version after restart.


wlc-fw_upgrade7.png

wlc-fw_upgrade8.png


  • 6.Test wireless network on new firmware version.

 

dzbanek 2012-01-07

This site uses cookies. Some of the cookies we use are essential for parts of the site to operate and have already been set. You may delete and block all cookies from this site, but parts of the site will not work.