1.How to disable obtaining config via tftp(how to disable warning error downloading config via tftp) in Cisco 1841?
2.Is it possible to log in directly to enable mode in Asa firewall using radius protocol?
3.Is it possible to log in directly to enable mode in Cisco Catalyst switch?

4.Is it possible to use bigger than 128MB compact flash card in Cisco router 1841?

5.During copy IOS to flash I get O!!!O!!!O!!!!O!!!!!!O!!!O

6.I have a problem to apply access-list to interface. There are errors:

Cannot add policy to rule engine ERROR: Unable to assign access-list inside to interface inside


1.Use command "no service config".
2.No, only TACACS-a allows it.
3.Yes, but it depends on IOS version.

4.Yes,it is. I am using 256 MB flash card without any problems.

5.Probably you do not have space on flash card for new IOS.

6.If there is a huge number of ACLs you probably reached maximum number of elements,e.g. for 5520 recommended max. number of elements is 750k

To check the size of elements in acl type command "sh access-list | i eleme"

This site uses cookies. Some of the cookies we use are essential for parts of the site to operate and have already been set. You may delete and block all cookies from this site, but parts of the site will not work.